Reference Guide

1604 Menu reference

Output Bus Meters

When selected with a check mark, output bus meters are displayed. When unchecked, output bus

meters are not displayed.

Record Meter Options > Peak

Available in the Playback Meter Options, Record Meter Options, and Mains Meter Options

submenus, this command sets the meter to Peak.

For more information about Peak meter display, see “Metering” on page 899.

Record Meter Options > RMS

Available in the Playback Meter Options, Record Meter Options, and Mains Meter Options

submenus, this command sets the meter to RMS.

For more information about RMS meter display, see “Metering” on page 899.

Record Meter Options > Peak + RMS

Available in the Playback Meter Options, Record Meter Options, and Mains Meter Options

submenus, this command sets the meter to Peak + RMS.

For more information about Peak + RMS meter display, see “Metering” on page 899.

Record Meter Options > Show Labels

This command toggles on/off the meter labels.

Record Meter Options > Hold Peaks

This command causes a meter to hold the most recent peak for a short time. The peak volume level

recorded by the meter is marked by a small white line which remains for a moment if lock peaks is

not checked or until the end of playback or recording if Lock Peaks is checked.