Reference Guide

1597
Select Punch Region
Menu reference
Select Punch Region
This command, which you find by right-clicking in the “Time ruler” on page 2059, sets the selection
start and end times to the Punch In and Punch Out times.
For more information about punch recording, see “Punch recording” on page 305.
Jump
This command causes an automation envelope to make a 90 degree “jump” when it reaches the
next node.
See:
“Creating and editing automation envelopes” on page 1119
Linear
This command draws a straight line between two nodes.
See:
“Creating and editing automation envelopes” on page 1119
Fast Curve
This command creates a curve between nodes which changes rapidly at first, and slower as it nears
the second node.
See:
“Creating and editing automation envelopes” on page 1119
Slow Curve
This command creates a curve between two nodes which changes slowly at first, then rapidly as it
nears the second node.
See:
“Creating and editing automation envelopes” on page 1119