Reference Guide

1129
Creating and editing automation envelopes
Automation
Automation editing mouse cursors
The mouse pointer provides helpful information when editing automation envelopes. The mouse
pointer informs you if you are moving a single node, multiple nodes, a line segment, or a time
selection. The following table shows the various mouse cursors.
For a list of all global tool mouse cursors, see “Mouse cursors” on page 508.
See:
“Automation” on page 1101
“Quick automation guide” on page 1103
“Automation methods” on page 1104
“Automation write modes” on page 1105
“Automation time base” on page 1107
“Automation Read and Automation Write buttons” on page 1108
“Recording individual fader or knob movements” on page 1109
“Automation lanes” on page 1111
“Automating track and bus mute” on page 1130
“Envelope mode and Offset mode” on page 1131
“Converting MIDI controllers to envelopes” on page 1134
“Snapshots” on page 1135
“Automating effects” on page 1136
“Recording automation data from an external controller” on page 1138
Mouse cursor Description
Move a single envelope node
Move multiple selected envelope nodes
Move an envelope line segment
Adjust selected envelope region up/down
Table 186. Automation mouse cursors