Reference Guide

1091
The Gobbler interface
Sharing and backing up your projects on Gobbler
After you have signed in to the Gobbler service, the Gobbler module controls become activated.
Figure 344. The Gobbler module.
A. Connect to Gobbler B. Auto Backup current project C. Storage indicator D. Send project or
files E. Notifications from Gobbler
The Gobbler module contains the following controls:
• Connect to Gobbler . Connect to the Gobbler cloud based service. Click again to
disconnect from Gobbler.
• Auto Backup . Initiate an automated backup of the current project, unless the project has
already been backed up. This setting is per project. When Auto Backup is enabled, Gobbler will
continuously back up your project as you work. However, Gobbler is smart, so it won’t run any
CPU related tasks while you are working in SONAR. The color of the button indicates its state:
• Blue : The project is presently on auto-backup.
• Yellow : The project is already backed up, but paused (not active).
• Storage indicator. Shows the available remaining storage in your Gobbler account. Shows
Offline if Gobbler is not enabled.
• Send Project Using Gobbler . Draft a message and send the current project to another
Gobbler user. SONAR will prompt you to save the project if it has been changed since the last
save. The Gobbler service will alert the recipients and grant them access to the files.
• Notifications from Gobbler . This button lights up if another Gobbler user sends files to
you. Click the button to launch Gobbler and view messages.
See:
“Sharing and backing up your projects on Gobbler” on page 1089
“Uploading files to Gobbler” on page 1092
“Troubleshooting” on page 1100
“Control Bar overview” on page 537
“Gobbler module” on page 568
C D E
A B