Reference Guide

1071
V-Vocal Editor
Using Region FX
To edit vibrato
1. Move the Vibrato/LFO tool over the vibrato segment that you want to edit.
The cursor displays a double-arrow icon when it is ready to edit vibrato: .
2. Drag the vibrato segment vertically to edit amplitude, or horizontally to edit frequency.
To fade-in vibrato
1. Move the Vibrato/LFO tool over the beginning of a vibrato segment.
The cursor displays a fade-in icon when it is ready to add a fade-in: .
2. Drag the vibrato segment to the right for the length of the fade-in that you want to add.
See:
“V-Vocal pitch-to-MIDI” on page 1074.
“Editing time” on page 1071.
Editing time
To edit timing with V-Vocal, the Time button in the Edit Mode section must be enabled.
To edit time
1. Make sure the Time button is enabled.
2. Move the Arrow tool near the vertical center of the graph until the cursor changes to the double
arrow, and click at each point where you want to preserve the original timing. A vertical green line
appears at each point that you click.
3. Now add new green lines between the existing ones.
4. Drag the new lines to the left or right to compress or expand each region.
Tips:
• Hold down the CTRL key while you move lines to move all the following lines by an equal amount.
• To erase lines, drag a region with the eraser. Timing reverts to its original condition in the areas
where you erase lines.
See:
“Editing formants” on page 1072
Tip:
• Holding the CTRL key down while you drag restricts vibrato editing to amplitude only.
• Holding the SHIFT key down while you drag restricts vibrato editing to frequency only.