Reference Guide

1068 Using Region FX
V-Vocal Editor
Pitch editing
Pitch editing requires that the Pitch button in the Edit Mode section is enabled. Here’s a description
of the interface in pitch editing mode:
• The yellow line is the edited Pitch curve and this line is the actual sounding pitch.
• The red line is the original Pitch curve and this line cannot be edited.
• The green dot is a Node. Nodes are automatically assigned to the start and end of the edited
region. You can select the specific region between the nodes if you click the yellow line between
the nodes.
• The white horizontal line is called Center Pitch. Center Pitch is used as a baseline for increasing
or decreasing vibrato or for pitch correction.
To change the pitch of a selected region
1. Use the Arrow tool to select the part of the yellow line that you want to transpose (make sure that
the Pitch button in the Edit Mode section is enabled).
The selected region turns blue to show that it is selected.
2. Drag the yellow line up or down.
Nodes appear automatically when you shift pitch.
Tips:
• CTRL-dragging snaps the pitch to the pitch correction grid. SHIFT dragging moves the pitch by
100 cent increments.
• You can also edit pitch by dragging a node up or down.
• You can undo each edit you do by pressing CTRL+Z. You can use this command repeatedly to
undo multiple edits.