Reference Guide

1025
ProChannel (Producer and Studio only)
To close the fly-out panel
Do one of the following:
• Click anywhere outside the fly-out panel, such as the Clips pane.
• Click the X button in the top right corner of the fly-out panel.
To keep the fly-out panel open
Click the pin button in the top right corner of the fly-out panel.
The fly-out panel will remain open until either of the following happens:
• The track focus changes.
• Other major UI changes occur, such as floating the Inspector, or any other change that causes the
parent ProChannel module to be closed.
See also:
“To interact with the QuadCurve Equalizer graph” on page 1004
“QuadCurve Equalizer fly-out panel touch gestures” on page 1177
See:
“ProChannel (Producer and Studio only)” on page 999
“Using ProChannel” on page 1003
“ProChannel modules and controls” on page 1008
“PC76 U-Type Channel Compressor module (Producer only)” on page 1014
“PC4K S-Type Bus Compressor module (Producer only)” on page 1016
“Tube Saturation module (Producer only)” on page 1026
“Console Emulator module (Producer only)” on page 1027
“FX Chain module” on page 1031
“Tape Emulator module (Producer only)” on page 1039
Note: The following gestures do not close the fly-out panel:
• Clicking in the fly-out panel’s parent ProChannel module.
• Clicking in the parent track’s channel strip in the Track view or Console view.
• Clicking in the time ruler.
• Clicking in the Control Bar.