Reference Guide

1004 ProChannel (Producer and Studio only)
To reorder a module
The signal flows from top to bottom. Click a module’s gripper and drag the module up/down to the
desired position.
Figure 308. Drag a module’s gripper up/down to reorder the signal chain.
To select a module
Click a module to make it the active module. The active module is shaded slightly. You can use ACT
to control parameters in the active module, and all context menu commands operate on the active
module when right-clicking an empty space in ProChannel.
To specify the default ProChannel configuration
1. Insert and arrange the ProChannel modules in the desired order.
2. Do one of the following:
• To specify the default configuration for tracks. Right-click any empty space in a track’s
ProChannel and select Set Modules as Default for Tracks on the pop-up menu.
• To specify the default configuration for tracks. Right-click any empty space in a bus’
ProChannel and select Set Modules as Default for Buses on the pop-up menu.
To route ProChannel pre-effects bin or post-effects bin
By default, the ProChannel signal is routed prior to the channel’s effects bin (pre). To route
ProChannel after the effects bin (post), right-click any empty space in ProChannel and select Post-
FX bin on the pop-up menu.
To interact with the QuadCurve Equalizer graph
The QuadCurve Equalizer graph is divided into four sections, which correspond to the Low, Low-
Mid, Mid-High and High bands. When you move the mouse pointer over the graph, the current band
is highlighted.
To adjust a band’s gain, drag up/down.
To adjust a band’s frequency, drag left/right.
To adjust a band’s Q, hold down the ALT key and drag up/down.
To adjust parameters with finer precision, hold down the SHIFT key while dragging.
Note: The High Pass filter and Low Pass filter can not be edited from the graph.