User Manual

Cajun Manual Page 9
BOW ADJUSTMENTS
Peak Draw Weight Adjustment
Using a 3/16” hex wrench, turn the limb bolts clockwise to increase peak
weight and counter-clockwise to reduce peak weight. Bow weight will
increase or decrease approximately two to four pounds per turn.
IMPORTANT Both limb bolts must be adjusted equally. Likewise, do
not turn one limb bolt more than two turns ahead of the other when
making adjustments. Finally, limb bolts must never be backed out more
than 14 turns.
The adjustable multidraw cam equipped bow can be configured to
provide a draw length from 17” to 31” in 1” intervals. No bow press is
required to adjust the multidraw cam system. To adjust the draw length,
first remove the socket head cap screws located in the rotating module.
Next rotate the module to the desired draw length and reinstall the screw
in the corresponding hole. It may be necessary to pull the cable away
from the module to provide clearance for the module to rotate, see the
picture below. Next perform the same operation on the opposite cam. Be
sure that both the top and bottom cams are set to the same draw length
position.
The modules are labeled with the designation RH-XXX or LH-XXX for left
hand and right handed bows. If the bow is a RH bow, the module that
would fit the top cam would be designated RH-TOP, and for the bottom
cam the designation would be RH-BTM. The designation should be visible
to the user, opposite of the cam . If the bow is a LH bow, the module that
would fit the top cam would be designated LH-TOP, and for the bottom
cam the designation would be LH-BTM. The designation should be visible
to the user, opposite of the cam.