User Manual

Cajun Manual Page 21
Arrow Slide
1- Install ACS Slide over the nock if possible, if not, remove the
nock and replace when finished. Ensure that the wide flat part
of the slide faces rearward so that it impacts the pad.
2- Install the arrow stop and ironclad pad protector using the
stainless steel mounting screw. Place the pad on the arrow
shaft followed by the ironclad pad protector ensuring the holes
are aligned. Secure using the stainless screw. Do not over
tighten!
3- (A)Attach the slide to the string by threading the line through
the back of the slide, over the top, then back out the opposite
hole on the back of the slide. (B)(C)(D) Tie an overhand knot 4”
from the slide passing the entire arrow through the loop
starting with the point.
(A) (B)
(C) (D)