User Manual

Cajun Manual Page 15
Nocking Point and Nock Adjustment
Now that the initial centershot setting is complete, you need to verify
your arrow nocking point. Install the nocking point or string loop on the
bowstring so that when an arrow is nocked it creates a 90 degree angle to
the string. Another option is to use a process similar to the one used to
determine centershot. With an arrow in the rest and nocked on the
string, firmly hold another arrow against the shelf of the riser as
illustrated. Look down the arrows and verify that the arrows are parallel.
In other words, the spacing between the two arrows should be the same
along the entire length of the arrows. If not, adjust your nocking point up
or down to correct.
At this time, adjust arrow fletch position to correspond with the arrow
rest you are using. Such adjustments are done by simply rotating or
replacing the arrow’s nock. Carefully position the nock to provide proper
fletch clearance through the arrow rest. Your local Bear Archery dealer
can show you how to do this or can provide the service for you. Please
refer to the images on the next page for further reference.
Install All Accessories
After your arrow rest and nocking point are installed correctly you will
need to install all other accessories such as sights, quivers, silencers, peep
sights, stabilizers, etc. Before mounting ANY accessories to the limbs,
Refer to page 3 for important limb information.