Product Manual

6 — 15062781 D
Use the Flow Control Knob to select the ow prescribed by your
physician.
WARNING: IT IS VERY IMPORTANT TO SELECT ONLY THE
PRESCRIBED LEVEL OF OXYGEN. DO NOT CHANGE THE
FLOW SELECTION UNLESS YOU HAVE BEEN DIRECTED TO DO
SO BY A LICENSED CLINICIAN. THE OXYGEN CONCENTRATOR MAY BE
USED DURING SLEEP UNDER THE RECOMMENDATION OF A QUALI
FIED CLINICIAN.
Breathe normally through the nasal cannula.
To adjust ow rate:
Turn counter-clockwise to increase ow.
Turn clockwise to decrease ow.
The middle of the ball indicates ow rate. See picture below.
5
Adjust Flow Setting to Prescribed Level
Plug the AC power cord into an AC outlet.
Toggle the Power Switch to the On position.
When the Companion 5 is powered on properly, the green power
indicator on the LED Display will light up. All LED lights will
illuminate upon start-up. After the concentrator completes the
warm-up cycle, only the green light will remain on.
Note: After initially powering ON the device, please allow up to ten (10)
minutes for the device to reach its performance specications.
For OCSI Models: The O2 Light will illuminate for four (4)
seconds upon start-up. After this initial start-up, this light
is disabled for approximately ve (5) minutes while the
concentration rises to specications.
4
Power On and Warm Up
Power
Indicator
LED
Power
Switch