Installation Guide

FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT (205) 702-9101.

32-1/4 IN. 50/50 LOW DIVIDER STAINLESS STEEL SINK

Installation Instructions

PREPARE THE COUNTERTOP

1. Position the template (provided with your sink) front

to rear so the sink will not interfere with the cabinet;

secure with tape.

2. Trace the template and remove. Dry t the sink to

verify the measurements.

3. Following the countertop manufacturer’s

instructions, carefully cut the countertop on the

inside of the traced line.

4. Locate and drill the mounting holes, following the

countertop manufacturer’s instructions. Holes should

allow even spacing of mounting brackets around the

sink.

5. With the countertop inverted (upside down), fasten

the mounting

IMPORTANT: The cabinet must be installed, secured, IMPORTANT: The cabinet must be installed, secured,

plumb, and level BEFORE installing the sink.plumb, and level BEFORE installing the sink.

IMPORTANT: Cahaba undermount sinks should only IMPORTANT: Cahaba undermount sinks should only

be fastened to a solid surface countertop (i.e. granite, be fastened to a solid surface countertop (i.e. granite,

Corian® or Silestone®).Corian® or Silestone®).

INSTALL THE COUNTERTOP

1. Clean the bottom of the countertop and the top

flange (or lip) of the sink with denatured alcohol.

2. Apply a narrow bead of silicone adhesive sealant

evenly all around the top of the sink flanges.

3. Position and align the sink over the countertop

opening. Press silicone onto countertop.

4. Tighten fasteners until mounting brackets are

snug against sink. Check alignment of sink to the

countertop opening.

5. Tighten down fasteners evenly. Be careful not to

over-tighten.

6. Immediately remove excess sealant.

OUTLINE FOR UNDERMOUNT SINK CUTOUT

MOUNTING BRACKET FASTENER

INVERTED COUNTERTOP

APPLY SILICONE SEALANT AFTER CLEANING THE SINK EDGE AND

COUNTERTOP