Installation Guide

APRON FRONT STAINLESS STEEL SINK
Installation Instructions
FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT [phone].
©2017 CAHABA. ALL RIGHTS RESERVED.
3
INSTALL THE SINK
1. Lower the sink onto the supports and verify the sink is supported by the
frame.
2. Push the sink in to ensure the apron is ush to the front of the cabinet.
3. Verify the sink is level. Make any adjustments and shim as needed.
4. Secure the sink in place using the hardware provided
X IMPORTANT: The front sink apron must be secured to the front of the
cabinet by attaching fasteners through the cabinet front and into the
support framing. Failure of this step can lead to product damage.
X IMPORTANT: Cahaba is not responsible for sink or counter top if
damaged during installation. Be sure to inspect the sink for damage prior
to beginning installation.
X IMPORTANT: Metal edges may be sharp – use caution when handling.
INSTALL THE COUNTERTOP
5. Clean the bottom of the counter top and the top ange (or lip) of the
sink with denatured alcohol.
6. Apply a narrow bead of silicone adhesive sealant around the side and
back of the sink.
7. Carefully position and secure the sink to the counter top following the
manufacturer’s instructions.
8. Apply a thin bead of silicone sealant where the sink meets the counter
top and cabinet.
9. Immediately remove excess sealant.
X IMPORTANT: The enclosed cutout template will create a counter top
opening with a minimal (1/8” or less) reveal. It is recommended that you
discuss this with your installer and agree that this nished appearance is
the desired effect. Cahaba is not responsible for improper sink or counter
top installations.
X IMPORTANT: Cahaba apron front sinks should only be fastened to a solid
surface counter top (i.e. granite, Corian® or Silestone®).
X IMPORTANT: Make sure the top of the sink does not extend above the top
of the cabinet; otherwise it will interfere with counter top installation
FINAL STEPS
1. Following all local plumbing and building codes, install the faucet
according to the manufacturer’s instructions.
2. Connect the drain and piping.
3. Run water into the sink and check all connections for leaks.
APPLY SILICONE SEALANT AFTER CLEANING THE
SINK EDGE AND COUNTERTOP
APPLY SILICONE SEALANT WHERE THE SINK
MEETS THE COUNTERTOP AND CABINET
For warranty issues or questions,
contact Cahaba at [phone].