Technical data

10
Descaling instructions
• Begin with Machine Off, Empty and rinse used capsule drawer and drip tray, and lower lever.
• Remove and empty the water tank.
• Mix 125ml of the Cafetto Organic Descaling agent and 625ml of water (to make 750ml of
solution), add to water tank and replace.
• Place a container (at least 750ml) under the coffee dispensing spout.
• Press and hold the buttons A - B and at the same time turn on the machine (B Button will
be on and D light will blink).
• Press the B button to start the descaling cycle.
• The appliance will dispense the descaling solution at intervals:
- 5 doses with a 4 minute pause between each one, Total time approx 25 minutes.
- Buttons must not be pressed, the D indicator light blinks alternately
• When the fi rst step is complete, the B button lights up beeps twice. The water tank is
empty.
• Rinse water tank and fi ll it with fresh drinking water to max line.
• Empty and rinse used capsule drawer, the drip tray and container & replace.
• Press the B button to start the rinse cycle.
• Rinse water (about 500 ml) will be run through the appliance.
• When the rinse cycle is complete, the machine beeps and A-B-C buttons will blink at the
same time; (machine warming up).
• When the buttons turn on and remain steadily lit, the appliance is ready for use.
• Rinse water tank and fi ll it with fresh drinking water.
• Empty and rinse used capsule drawer, the drip tray and container & replace.
Restore original settings (RESET)
These instructions, allow you to reset the machine back to its factory settings – Helpful if you
experience an issue with the machine, or you have changed the pour levels for example and
cannot change them back to their original levels.
The reset of the machine can be done with the following procedure:
1. Start with machine OFF.
2. Start with silver handle up.
3. Hold down Espresso button (A button. Top left / white button).
4. While still holding down the A Button - Switch ON and then,
after 1sec, close and open the silver handle,
5. 5 beeps is signaling that the reset has been done; then release
the espresso button.
NB: At the end of
this procedure,
machine is driven
in 1st use state
and you will need
to go back and
perform the fi rst
use procedures.
1
5
2
3
A B
C
D