Installation Guide

49-60820 31
INSTALLATION INSTRUCTIONS
MEASURE CABINET
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
:LGWK:VKRXOGQRWEHOHVVWKDQ´
cm). The refrigerator will be placed approximately
in the middle of this opening.
MATERIALS YOU MAY NEED (not included)
TOOLS YOU WILL NEED
Pencil
´PP'ULOO%LWDQG
Electric or Hand Drill
Tape measure
´PP1XW'ULYHU
Lag Bolts
´PP[´PP
Anchor Sleeves
´PP2'
For Anti-Tip Bracket Mounted on CONCRETE Floors Only
Drill Bit Appropriate for Anchors
AT-1
LOCATING THE ANTI-TIP
FLOOR BRACKET
Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W, and in line
with the desired location of the RH side of the
refrigerator (see Figure 1).
Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
DSSUR[LPDWHO\ó´FPIURPWKHHGJH
of the sheet or the RH side of the refrigerator.
Hold down in position and use the anti-tip floor
bracket as a template for marking the holes
based upon your configuration and type of
construction as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
,WLV5(48,5('WRXVHDWOHDVWVFUHZVWR
mount the floor bracket (one on each side of
the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable mounting configurations for
screws. Identify the screw holes on the anti-tip
floor bracket for your configuration.
AT-2
A
B
C
Baseboard
Thickness or
Countertop
Overhang
(Whichever Is
Larger) Plus
Any Desired
Clearance
Rear Wall
Front
RH Side
W
REFRIGERATOR
Figure 1 – Installation Overview
Base Bracket
on the
Refrigerator
2 Wall Holes
RH Side of
Refrigerator
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
ó´
Locator
Template Sheet
Floor Bracket
to Install
RH Holes
Rear RH
Corner of
Cabinet Wall
WARNING
Tip Over Hazard.
Built-in style models (CYE, CWE) are top heavy,
especially with any doors open. These models must
be secured with the anti-tip floor bracket to prevent
tipping forward, which could result in death or
serious injury. Read and follow the entire installation
instructions for installing the anti-tip floor bracket
packed with your refrigerator.
NOTE:
If you did not receive an anti-tip bracket with your
purchase, visit us online at
cafeappliances.com/parts to receive one at no cost.
In Canada, cafe.applances.ca/parts.
For installation instructions of the bracket, visit:
cafeappliances.com/literature. In Canada, cafe.
applances.ca/literature.
Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
Anti-Tip Floor Bracket Installation (Models CYE and CWE only)