Installation Guide

Work with one knob at a time to ensure you don’t mix up replacement pieces.
Make sure you check the writing on each of your knobs and set them out in the order
you will replace them. This will help ensure you don’t put them on in the wrong order.
IMPORTANT!
Instructions for Replacing Knobs
Instrucciones En Español | Instructions En Français:
www.cafeappliances.com/kit-instructions
I. Removing the Current Knob
1. Make sure all knobs are in the OFF position. Note: Microwave oven knob
does not have an OFF position.
2. Take note of the OFF position orientation.
3. Choose which knob you will work with first.
4. Remove the knob by grasping the sides and pulling away from the
appliance until the knob is free from its shaft. You may have to wiggle it
slightly as you pull.
II. Installing the Replacement Knob
1. Match the replacement knob with the knob you’ve removed—make sure
they have the same writing and markings.
2. Hold the replacement knob so that OFF is at the orientation noted in
Section I. Make sure it lines up properly with the shaft.
3. Push the knob onto the shaft as far as possible so it fits snuggly.
Repeat the above removal and installation steps for each knob until they
have all been removed and replaced.
fig. 2
fig. 1