Installation Guide

18 49-1000329 Rev. 0
Ice Bucket and Dispenser
• Open the ice box door on inside of the left door.
• Pull up and out on the ice bucket in the left hand door
to remove it from the compartment .
• To replace the ice bucket, set it on the guide brackets
and push until the ice bucket seats properly.
• If bucket cannot be replaced,
rotate the ice bucket fork 1/4 turn
clockwise.
USING THE FREEZER: Automatic Icemaker
Lift and pull
Ice Box
Door
Automatic Icemaker
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
The icemaker will produce seven cubes per cycle
approximately 100–130 cubes in a 24-hour period,
GHSHQGLQJRQIUHH]HUFRPSDUWPHQWWHPSHUDWXUHURRP
temperature, number of door openings and other use
conditions.
The icemaker will fill with water when it cools to 15°F
(-10°C). A newly installed refrigerator may take 12 to 24
hours to begin making ice cubes.
If the refrigerator is operated before the water line
connection is made to the unit or if the water supply to
an operating refrigerator is turned off, make sure that
the icemaker is turned off. Once the water has been
connected to the refrigerator, the icemaker may be
turned on using the controls.
<RXPD\KHDUDEX]]LQJVRXQGHDFKWLPHWKHLFHPDNHU
fills with water.
To fill the bucket to maximum capacity after installation,
dispense 3-4 cubes at 12 hours and 18 hours. Allow 2-3
days for the bucket to completly fill with ice.
Throw away the first few
batches of ice to allow
the water line to clear.
Be sure nothing interferes
with the sweep of the
feeler arm.
When the bin fills to the
level of the feeler arm,
the icemaker will stop producing ice. It is normal for
several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker cycle multiple
times when making one batch of ice.
CAUTION
7RPLQLPL]HWKHULVNRISHUVRQDOLQMXU\
avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the refrigerator is
plugged in.
To turn the icemaker ON/OFF, use the Settings button
to navicate to the Icemaker selections. See CONTROLS,
page 8.
WARNING
Connect to potable water supply
only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40
and 120 psi (275-827 kilopascals).