Installation Guide

12
DOOR ADJUSTMENT MECHANISM
Door Adjustment Mechanism is located on both the right and left doors at the bottom hinges. Only
the left side Adjustment Mechanism is shown in this manual.
NOTE: Adjust the doors inward only until the center gap is even. Over-adjusting can damage the
center seals and make the doors more difficult to open.
A. Using 3/16” hex key, tighten Vertical Adjustment Screw to adjust door up and loosen to adjust
door down.
B. Horizontal Adjustment Screws pivot
the door about an axis. Using a 1/8”
Hex Key, loosen both screws, then
tighten appropriate screw to pivot
door. Once door is in place, verify
both screws are tightened.
EXAGGERATED EXAMPLES FOR LEFT DOOR ADJUSTMENT
Example 1: Left door low,
center gap even.
Steps for adjustment:
A. Tighten left Vertical
Adjustment Screw.
B. If left door is still low, loosen
right Vertical Adjustment
Screw.
Example 2: Left door low,
center gap larger at bottom.
Steps for adjustment:
A. Loosen inside Horizontal
Adjustment Screw.
B. Tighten outside Horizontal
Adjustment Screw until
center gap even.
C. If left door is still low, tighten
left Vertical Adjustment
Screw.
D. Tighten inside Horizontal
Adjustment Screw.
Example 3: Left door high,
center gap larger at top.
Steps for adjustment:
A. Loosen outside Horizontal
Adjustment Screw.
B. Tighten Outside Horizontal
Adjustment Screw until
center gap even.
C. If left door is still low, tighten
Left Vertical Adjustment
Screw.
D. Tighten Inside Horizontal
Adjustment Screw.
Vertical Adjustment Screw
Horizontal Adjustment Screws
13
FINAL INSTALLATION CHECKLIST
• Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check that all packing material and tape have been removed. Failure to remove these materials
could result in damage to the appliance once the appliance has been turned on and surfaces
have heated.
• Remove all items from inside the oven.
• Check to be sure that the mounting screws are installed and flush with the side trim
(see Section 10).
• Check that the bottom trim is installed properly (see Bottom Trim Installation).
• Ensure that air duct opening at bottom of unit is free of obstructions.
• Check that oven rack guides (if applicable) are installed correctly and oven racks function smoothly.
• If applicable - install handles following handle installation instructions and check that both ends are
secured.
OPERATION CHECKLIST
• Turn on the power to the oven (refer to your Owner’s Manual). Verify that the bake and broil
units and all cooking functions operate properly.
• See your Owner’s Manual for the troubleshooting list.
• Be sure all of the oven controls are OFF before leaving the oven.
• Open the door completely and ensure that there is sufficient clearance to surrounding cabinets
and counter tops.
Some models have custom handles. Please follow the instructions with the handles for
proper installation.