Installation Guide

31-2001018 11-21 GEA (sheet 2 of 2)
10
MOUNT THE OVEN
WARNING
Mounting screws must be used. Failure to do so could result in the oven
falling out of the cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines
the edge of oven cavity.
NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening
as it will go and is centered.
NOTE: If the cabinet is particle board, you must use #8 x ¾” particle board screws. These may
be purchased at any hardware store.
A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws
provided.
B. Secure the oven cabinet with the screws provided.
The Screws Must
Be a Minimum of
¼” (6 mm) From the
Front of the Cutout.
Mounting
Hole
Locations
(hole locations
may vary)
11
OVEN RACK GUIDE INSTALLATION
A. Locate included oven rack guide mounting hardware.
B. Place oven rack guides on cavity wall studs with metal posts towards back of cavity as shown.
C. Install guides using the 8 provided mounting nuts.
Oven rack
guide shown
in place.
Metal Posts to
be installed in
the rear of cavity
French doors removed
for illustration clarity only
French doors removed
for illustration clarity only