Installation Instructions

Safety Information
2
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
—
Save these instructions
for local inspector’s use.
IMPORTANT
—
Observe all governing codes
and ordinances.
• Note to Installer
—
Be sure to leave these
instructions with the Consumer.
• Note to Consumer
—
Keep these instructions
with your Owner’s Manual for future reference.
• Skill Level — Installation of this appliance
requires basic mechanical and electrical skills.
• Completion Time
—
1 Hour.
• Proper installation is the responsibility
of the installer. Product failure due to improper
installation is not covered under the warranty.
See Owner’s Manual for warranty information.
NOTE: This oven is only approved to be installed
under the specific models as labeled on this unit.
IMPORTANT
—
Use this oven only for its
intended purpose. Never use the oven for
warming or heating a room. Prolonged use
of the oven without proper ventilation can be
hazardous.
CAUTION
For personal safety, remove
house fuse or oven circuit breaker before
beginning installation to avoid severe or fatal
shock injury.
CAUTION
For personal safety, the
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of the oven and drawer, plus additional oven
loads.
CAUTION
If installing the Advantium/
Convection 120V Oven below 36Ǝ, you must
use the plastic bottom trim due to burn risk
to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.
CAUTION
If installing the Advantium/
Convection 120V Oven below 36Ǝ, do not
remove the plastic door trim due to burn risk
to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.
MODELS AVAILABLE
Profile Models:
PSB9120WW – White*
PSB9120BB – Black
PSB9120SS – Stainless Steel
PSB9120ES – Slate
PWB7030SL – Stainless Steel
PWB7030EL – Slate
PSB9120BL – Black Stainless Steel
Monogram Models:
ZSC1201SS – Stainless Steel
ZSC1202SS
– Stainless Steel**
Café Model:
CSB9120SS – Stainless Steel
CWB7030SL – Stainless Steel
*No color-matched drawer available for this
model.
**This unit cannot be installed with an
accessory storage drawer.
CONTENTS
Design Information
Models Available ...............................................2
Product Dimensions and Clearances ................3
Tools Required ..................................................3
Parts Supplied ...................................................3
Advance Planning .............................................3
Installation Preparation
Electrical Requirements ....................................4
Preparing the Opening (Standard) .................5-8
Preparing the Opening (Flush Mount) ..........9-10
Storage Drawer Preparation
Standard .........................................................11
Flush ...............................................................11
Installation Instructions
Step 1, Remove Packaging and Parts ............12
Step 2, Door Trim Removal for above 36”
Installation only ...............................................13
Step 3, Slide the Oven into the Cutout ...........13
Step 4, Install Bottom Trim ..............................14
Step 5, Install Bottom Trim with Accessory
Drawer ........................................................... 14
Step 6, Install Mounting Screws ......................14
Step 7, Finalize Installation ............................. 14