Specification Sheet

CSB912P2NS1
Café™ 27" Five in One Oven
with 120V Advantium® Technology
For answers to your Café™ product questions, visit our website at cafeappliances.com.
WARRANTY
Parts warranty
Limited 1-year entire appliance
Limited 5-year magnetron tube
Labor warranty Limited 1-year entire appliance
Warranty notes See written warranty for full details
DIMENSIONS AND INSTALLATION INFORMATION
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating.
Note: 2" minimum between cutouts when installed
above warming drawer or single wall oven.
Installation information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Note: Use of the accessory drawer will replace
the bottom trim piece for applicable installations.
Please see installation instructions for full details.
1" MIN. above toekick or adjust
to oven installation height
2" MIN. between cutouts
3" MIN. between cutouts
recommended - 2" MIN. required
Cutout height and width
per drawer requirements
Junction box location
A
B
Construct Solid Bottom
MIN. 3/8" Plywood Supported by
2 x 4 or 1 x 2 Runners, all Four Sides.
(Each platform must be able to support
cabinet load, weight of oven, and
additional oven loads)
4-3/16"
Conduit
(46" long)
Cabinet width
21-1/2"
To back
of Control
20-1/4"
29-3/4"
C
C
L
2x4’s or
equivalent
solid floor
Suitable
bracing
to support
runners
21-5/8"
over centerline
of cabinet
(Platform must be able to support
cabinet load, weight of oven, and
additional oven loads)
4-3/16"
25-1/4"
Cutout width
Junction
box location
17-1/2"
Cutout height
26-3/4"
20-1/4"
21-1/2"
Back of Control
Conduit
(48-1/2"
long)
B
30"
5" MIN. from
floor 1" MIN.
above toekick
A
Advantium Wall Oven Dimensions (in inches)and
Cabinet Installation (in inches)
Note: Cabinets installed adjacent
to wall ovens must have an adhesion
spec of at least 194° F temperature rating.
23-1/2"
Cutout depth
C
A = The unit overlap is 1-3/4" but allow 1-7/8" clearance from top edge of cutout
B = The unit overlap is 3/4" but allow 7/8" clearance from side edges of cutout
C = The unit overlap is 1" but allow 1-1/8" clearance from bottom edge of cutout
Construct Solid Bottom
MIN. 3/8" Plywood
Supported by 2 x 4
or 1 x 2 Runners,
all Four Sides.
(Platform must be
able to support cabinet
load, weight of oven,
and additional
oven loads)
26-3/4"
CSB912M2NS5
CSB913M2NS5
CSB923M2NS5