Range LP Conversion Instructions
Broil 
2UL¿FH
Oven 
Light
Low setting adjustments must be made with other burners in 
operation on a medium setting. This procedure prevents the 
ORZÀDPHIURPEHLQJVHWWRRORZUHVXOWLQJLQWKHÀDPHEHLQJ
extinguished when other burners are turned on.
A.  Turn on all surface burners to medium setting.
% 7XUQWKHNQRERQWKHEXUQHUEHLQJDGMXVWHGWR³/2´
& 5HPRYHWKHNQREDQGLQVHUWDVPDOOÀDWEODGHVFUHZGULYHU
into the valve shaft and/or side adjustment screw(s) as 
shown and turn clockwise to fully tighten down the bypass 
screw(s). Repeat for all valves.
' ,IÀDPHDSSHDUVWRRORZRUXQVWDEOHVORZO\WXUQE\SDVVVFUHZ
FRXQWHUFORFNZLVHXQWLODVWDEOHÀDPHH[LVWVIRUHDFKEXUQHU
Remember, other burners must be turned on to medium. 
  SPECIALTY BURNERS 
 Multi-Ring Burner±7KHRXWHUULQJRIÀDPHVVKRXOGEH
DGMXVWHGZLWKWKHNQREDWWKH0('E\
adjusting the set screw in the center 
YDOYHVKDIW7KHÀDPHVVKRXOGEH
adjusted so that they barely curl over 
the top edge of the burner cap. The 
FHQWHUULQJRIÀDPHVVKRXOGEHDGMXVWHG
with the knob at the LO setting by 
adjusting the set screw to the right of 
the valve shaft.
( $GGLWLRQDOO\IRUHDFKEXUQHUEHLQJDGMXVWHGTXLFNO\RSHQ
DQGFORVHWKHRYHQGRRUZKLOHREVHUYLQJÀDPH,IÀDPHLV
extinguished, continue adjusting bypass screw for a larger 
ÀDPH5HSHDWGRRURSHQLQJVXQWLOÀDPHLVVWDEOH
F. Replace the knob.
CONVERTING THE OVEN BURNERS
ADDITIONAL INFORMATION
BAKE BURNER ORIFICE
1. Remove oven racks, door and oven bottom. Remove the 
1/4” hex screws securing the bake burner.
 7KHEDNHEXUQHURUL¿FHLVRQWKHJDVYDOYHORFDWHGEHKLQG
WKHZDUPLQJGUDZHU/LIWWKHEXUQHURႇWKHRUL¿FHDQGDSSO\
D´VRFNHWRQDQH[WHQVLRQWRWKHKH[EDVHRIWKHRUL¿FH
RQWKHJDVYDOYH/RRVHQWKHRUL¿FHE\WXUQLQJFRXQWHU
clockwise and remove.
 6HOHFWWKHSURSDQHEDNHRUL¿FHIURPWKHNLWDQGLQVWDOOLWRQ
the gas valve. Tighten until snug.
BROIL BURNER ORIFICE
1. Remove the 1/4” hex screw securing the broil burner and 
DOORZLWWRKDQJGRZQIUHHRIWKHEURLORUL¿FH
 $SSO\D´ZUHQFKWRWKHKH[EDVHRIWKHRUL¿FH/RRVHQ
WKHRUL¿FHE\WXUQLQJFRXQWHUFORFNZLVHDQGUHPRYH
 6HOHFWWKHSURSDQHEURLORUL¿FHIURPWKHNLWDQGLQVWDOOLWRQ
the broil elbow. Tighten until snug.
 5HSODFHWKHEURLOEXUQHURYHUWKHRUL¿FHDQGUHSODFHWKH
screw securing the burner. 
Lift 
Burner
%DNH%XUQHU2UL¿FH
ADJUSTING LOW FLAME SETTING 
ON COOKTOP BURNERS
SPECIAL NOTE: 
To convert the oven back to natural gas, reverse the 
instructions given in making propane adjustments.
PROPANE CONVERSION INSTRUCTIONS
31-11074-3 12-19 GEA
CGS700M, CGS986, and CGS700P
NOTICE:
This product cannot be converted to propane by adjusting 
WKHRYHQRUL¿FHV7KHRUL¿FHVPXVWEHUHSODFHGIRU
propane.
NOTICE:
2QFHWKHFRQYHUVLRQLVFRPSOHWHDQGFRQ¿UPHG¿OORXWWKH
propane sticker and include your name, organization and 
date conversion was made. Apply the sticker to the range 
near the regulator to alert others in the future that this 
appliance has been converted to propane. If converting 
back to natural gas from propane, please remove the 
sticker so others know the appliance is set to use natural 
gas.
NOTICE:
6DYHWKHVHRUL¿FHVIRUIXWXUHFRQYHUVLRQEDFNWRQDWXUDOJDV
BURNER OUTPUT RATINGS: BTU/HR
NG (Natural) Gas 5” W.C.P.
BURNER
BTU 
RATE
ORIFICE 
SIZE (mm) COLOR MARKING
LF 21,000
LF1 N/A 0.045 None 114N
LF2 N/A 0.045 None 114N
LF3 N/A 0.045 None 114N
LFC N/A 0.025 None 63N
LR 5,000 0.040 :KLWH3XUSOH 101N
CF 9,500 0.0555 Yellow 141N
CR 9,500 0.0555 Yellow 141N
RF 15,000 0.070 Brown 178N
RR 12,000 0.061 Red 155N
Broil 16,500 0.071 Blue/Black 071N
Bake 16,000 0.070 None 50
Adjustment screws for multi-ring burner only
Adjustment 
screw for 
outer ring
Adjustment 
screw for 
center ring
Center adjustment screw only for all other burners.
198
III
Denotes 1.98mm Orifice size opening
Denotes Natural Gas
N
Flames
Burner Cap
ADJUSTING AIR SHUTTER SETTINGS 
FOR OVEN BURNERS
 :LWKD3KLOOLSVKHDGVFUHZGULYHUORRVHQWKHVFUHZV
securing the air shutter on the bake burner. Adjust the air 
shutter to the dimension given in the above table.
2.  Turn on the gas.
3.  Turn on the electricity.
4.  Reinstall the oven door.
5.  Turn on the bake burner. 
2YHQEXUQHUÀDPHPXVWEHREVHUYHGZLWKWKHGRRUFORVHG
WRSURSHUO\FKHFNÀDPHFKDUDFWHULVWLFV
 $V\RXZDWFKWKHÀDPHZLWKWKHRYHQGRRUFORVHGFKHFN
the following through the oven door window.
 D)RU1DWXUDO*DVLIWKHÀDPHVDUH\HOORZRSHQWKHDLU
shutter more.
 E,IWKHÀDPHVEORZDZD\RUÀXWWHUIURPWKHEXUQHUFORVH
the air shutter slightly.
 7XUQEDNHEXUQHURႇDQGUHSHDWZLWKEURLOEXUQHU
 &KHFNLQJWKHÀDPHVL]H
 It should be approximately 1/2” 
to 3/4” long for the bake and broil 
burners.
 The combustion quality of the 
EXUQHUÀDPHVQHHGVWREHGHWHUPLQHGYLVXDOO\
 127(,IEXUQHUÀDPHVORRNOLNH$IXUWKHUDLUVKXWWHU
adjustment to the bake buner is required. Normal 
EXUQHUÀDPHVVKRXOGORRNOLNH%RU&GHSHQGLQJ
on the type of gas you use. With propane gas, some 
yellow tipping on the outer cones is normal.
)RUHLJQSDUWLFOHVLQWKHJDVOLQHPD\FDXVHDQRUDQJHÀDPHDW
¿UVWEXWWKLVZLOOVRRQGLVDSSHDU
9. 
When all adjustments are made and the results are 
satisfactory:
  a. Retighten the air shutter screws.
  b. Replace the oven bottom.
  c. Replace the storage drawer.
Screw
Air shutter
WARNING
 If you attempt to measure the inner cone 
RIWKHÀDPHSOHDVHXVHFDXWLRQEXUQVFRXOGUHVXOW
The air shutters should be turned to the marked settings NG or 
propane or set according to the following table. 
BURNER
AIR SHUTTER 
SETTING FOR PROPANE
AIR SHUTTER 
SETTING FOR NG
Bake Full open 0.280”
Broil 0.690” 0.690”
(A) Yellow flames:
Further Adjustment
Required
(B) Yellow tips on 
outer cones:
Normal for Propane (LP) Gas
(C) Soft blue flames:
Normal for Natural Gas


