Specification Guide

CMB903P2NS1
Café™ 30" Pro Steam Oven
DIMENSIONS AND INSTALLATION INFORMATION
Prepare the opening: The steam oven can be installed in combination with other
Café appliances. Always follow each product's Installation Instructions to compete
the installation.
Single oven installation: Order a 30" wide single oven cabinet or cut the opening
in a wall to the dimensions shown.
* For existing cutouts, a maximum width of 28-1/2" is acceptable. If the
opening is slightly wider, secure a furring strip on each side of the
cutout for securing the oven.
- Allow 3/4" to 2-1/8" case trim overlap on the sides. The amount of overlap on the
sides depends on the actual cutout width. Allow case trim overlap on the top.
- Oven overlaps will conceal cut edges on all sides of the opening.
When installed over a single oven or a warming drawer, allow at least
1-3/4" between the two openings.
Construct a solid oven floor of 3/8" min. thick plywood supported by 2 x 4
or 2 x 2 runners on all sides.
- the support must be level and rigidly mounted, flush with the bottom
edge of the cutout.
* For existing cutouts, a maximum width of 28-1/2" is acceptable. If the
opening is slightly wider, secure a furring strip on each side of the cutout
for securing the oven.
Note: Additional clearances between the cutouts may be required. Check to be
sure the oven supports above the Warming Drawer location do not obstruct the
required interior depth and height. See Warming Drawer installation instructions
for details.
Installation Over a Wall Oven and Warming Drawer:
* For existing cutouts, a maximum width of 28-1/2" is acceptable. If the opening
is slightly wider, secure a furring strip on each side of the cutout for securing
the oven.
Note: Additional clearances between the cutouts may be required. Check
to be sure the oven supports above the Warming Drawer location do not
obstruct the required interior depth and height. See Warming Drawer installation
instructions for details.
Caution: For personal safety, the mounting surface must be capable of supporting
the cabinet load, in addition to the added weight of this approximate 80-pound
oven and 30-pound drawer, plus additional oven
loads of up to 50 pounds or a total weight of 160 pounds.
12 3/4"
(32.3)
5 1/4"
(13.3)
29 3/4" (75.6)
FRONT VIEW (SHOWING CUTOUT OVERLAP)
25" (63.5)
23 1/2" (59.6)
SIDE VIEW
2.5"
(6.4)
24 3/4" (62.9)
2 3/4"
(7.0)
27 3/4"
(70.4)
13"
(33.0)
min
TOP VIEW
OPEN OVEN DOOR
SHOWING DOOR CLEARANCE
6 3/8" (16.2)
18 5/8"
(47.3)
CMB903P2NS1
17 3/4"
(45.0)
7/8" (2.2)
25 1/4" (64.1)
Attention Electrician:
A 240V, 60Hz, 20 Amp circuit is required. An individual properly
grounded branch circuit or circuit breaker is required. Hardware
junction box is required for built-in product.
© 2020 GE Appliances PC 94761 07/20
For answers to your Café™ product questions, visit our website at cafeappliances.com.
ADDITIONAL ACCESSORIES
CXWS0H0PMBZ
Brushed Bronze
1 handle
CXWS0H0PMBT
Brushed Black
1 handle
CXWS0H0PMCU
Brushed Copper
1 handle