Installation Guide

49-60745 Rev. 4 5
Remove Packaging
IMPORTANT: Do not remove any permanent instruction
labels inside your ice machine or the Tech Sheet that is
fastened behind the lower access panel.
■Removetapeandanylabelsfromyouricemaker
beforeusing(exceptthemodelandserialnumber
label).
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can also
be easily removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
■Donotusesharpinstruments,rubbingalcohol,
flammable fluids or abrasive cleaners to remove tape
or glue. These products can damage the surface of
youricemaker.Formoreinformation,seeImportant
Safety Instructions.
1. POWER ON/OFF - Press to turn the ice machine on or off.
2. ICE MAKING - Glows white when the unit is ON.
3. CHECK WATER - Glows red when there is not water supplied to the machine.
4. TIME TO CLEAN - Glows yellow when it's time to clean the machine. The light will switch ON after 6 months of
use. It will remain on until the ice making system is cleaned using the process in the Care and
Cleaning section.
5. CLEAN RESET -PressedwithPowerbuttonfor5secondstostartthecleaningprocess(seeCareandCleaning).
POWER
ON/OFF
CLEAN
RESET
TIME TO
CLEAN
CHECK
WATER
ICE
MAKING
Packaging
USING THE ICE MACHINE: Packaging/ Controls
1 2 3 4 5
Controls