Installation Guide

12 49-60745 Rev. 4
INSTALLING THE DOOR PANEL
The ice machine is supplied without a conventional
door covering, allowing the attachment of a door panel
or a custom panel.
NOTE: If the door swing is to be changed, it needs to
be done BEFORE attaching the door panel.
Door Panel
Finisheddoorpanelswithhandlesareavailablefrom
GE Appliances for attachment to the ice machine. See
Accessoriesonpage20.
A custom panel of wood or other material not
exceeding 15 lbs can be used and must follow these
guidelines:
 width:147/8”
 height:between295/8”and305/8”
 thickness:5/8”to3/4”
For Custom Panel:
1. Measure overall height of the cabinet opening
wheretheicemachinewillbeinstalled(floorto
bottomofthecountertopedge).
2. Determinedesiredtoekickheight(bottomofdoor
tothefloor).Thiscanbeequaltotheadjacent
cabinet’s toekick height.
3. The clearance between the countertop and the top
oftheicemachineshouldbeatleast1/8”.
4. Subtract the toekick height and the clearance from
the opening height to determine the height of your
custom door panel.
5. Cut the panel to the specified width and height.
6. Determine the top of the panel. Measure and mark
hole locations.
7. Drill pilot holes on the back of the panel at your
markings.Useadrillstoptopreventdrilling
through the panel.
Cabinet
opening
1/8”orgreater
clearance
Toekick
height
13-9/16”
8-1/4”
6-25/32”
4-1/8”
1-1/16”
14-15/16”
14-7/8”
Centerline
13-31/64”
30-5/8”
29-5/8”
13/32”
ᴓ1/8”
TYP (10)
13/32”
Installation Instructions
INSTALLATION INSTRUCTIONS