Use and Care Manual

32 49-2001001 Rev. 1
Oven Light
Oven Probe
The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a
soap-filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end
of this manual.
Ŷ Do not immerse the temperature probe in water.
Ŷ Do not store the temperature probe in the oven.
Ŷ Do not leave the temperature probe inside the oven
during a self or steam clean cycle.
CARE AND CLEANING:2YHQ3UREH2YHQ/LJKW
WARNING
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
CAUTION
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
bare hands or a damp cloth can cause burns.
Oven Light Replacement (on some models)
To remove:
 7XUQWKHJODVVFRYHUFRXQWHUFORFNZLVHWXUQXQWLOWKHWDEV
of the glass cover clear the grooves of the socket. Wearing
latex gloves may offer a better grip.
2. Using gloves or a dry cloth, remove the bulb by pulling it
straight out.
To replace:
 8VHDQHZYROWKDORJHQEXOEQRWWRH[FHHG
watts. Replace the bulb with the same type of bulb that was
removed. Be sure the replacement bulb is rated 120 volts or
130 volts (NOT 12 volts).
2. Using gloves or a dry cloth, remove the bulb from its
packaging. Do not touch the bulb with bare fingers. Oil from
skin will damage the bulb and shorten its life.
3. Push the bulb straight into the receptacle all the way.
4. Place the tabs of the glass cover into the grooves of the
VRFNHW7XUQWKHJODVVFRYHUFORFNZLVHWXUQ
For improved lighting inside the oven, clean the glass cover
frequently using a wet cloth. This should be done when the
oven is completely cool.
5. Reconnect electrical power to the oven.
Oven Light Replacement (on some models)
To remove:
1. Turn the glass cover counterclockwise
WXUQXQWLOWKHWDEVRIWKHJODVV
cover clear the grooves of the socket.
Wearing latex gloves may offer a better
grip.
2. Remove the bulb by turning it counter-
clockwise.
To replace:
1. Replace bulb with a new 40-watt appliance bulb. Insert the
bulb and turn it clockwise until it is tight.
2. Place the tabs of the glass cover into the grooves of the
VRFNHW7XUQWKHJODVVFRYHUFORFNZLVHWXUQ
For improved lighting inside the oven, clean the glass cover
frequently using a wet cloth. This should be done when the
oven is completely cool.
3. Reconnect electrical power to the oven.
G9 Bulb
Socket
Tab
Glass cover
Receptacle
Use gloves
or cloth
Receptacle