Use and Care Guide
49-2000659 Rev. 1 9
IN CASE OF A POWER FAILURE
In the event of a power failure, the oven is inoperable 
and no attempt should be made to operate it. However, 
WKHVXUIDFHEXUQHUVPD\EHOLWZLWKDPDWFK8VLQJ
extreme caution, hold a lit match near the ports beneath 
the surface burner cap, then slowly turn the knob to the 
LITE position. Once lit, surface burners will continue to 
operate normally.
SURFACE BURNERS
Lighting a Surface Burner
WARNING
 Burners should be operated only 
when covered by cookware. Burner flames not 
covered by cookware present a risk of fire or 
clothing ignition. Never let flames extend beyond the 
sides of the cookware. Failure to comply may result 
in serious injury.
Make sure all burners are in their correct locations and 
fully assembled before attempting to operate any burner.
Select a burner and find its control knob. Push the knob 
in and turn it to the LITE position.
<RXZLOOKHDUDFOLFNLQJQRLVH²
the sound of the electric spark 
igniting the burner. When one 
burner is turned to LITE, all 
burners will spark. Sparking will 
continue as long as the knob 
remains at LITE. Once gas is 
ignited, turn the knob to adjust 
WKHIODPHVL]H
Automatic Reignition
The burners on this range will automatically relight if the 
flame goes out.
Using the Surface Burners
NOTES:
Ŷ 'RQRWRSHUDWHWKHEXUQHUIRUDQH[WHQGHGSHULRGRI
time without cookware on the grate. The finish on 
the grate may discolor or chip without cookware to 
absorb the heat.
Ŷ 'RQRWDWWHPSWWRGLVDVVHPEOHDQ\EXUQHUZKLOHDQRWKHU
burner is on. Damage to the product may occur.
Ŷ %HVXUHWKHEXUQHUVDQGJUDWHVDUHFRROEHIRUH\RX
place your hand, a pot holder or cleaning materials 
on them.
Your rangetop has sealed gas burners that offer 
convenience, cleanability and flexibility for a wide range 
of cooking applications.
Selecting a Flame Size
Watch the flame, not the knob, as you adjust heat. When 
UDSLGKHDWLQJLVGHVLUHGWKHIODPHVL]HVKRXOGPDWFKWKH
VL]HRIWKHFRRNZDUH\RXDUHXVLQJ)ODPHVODUJHUWKDQ
the bottom of the cookware will not heat faster and may 
EHKD]DUGRXV
These flames are too large for the pot
Push the control knob in and 
turn it to the LITE position.
Using the Range
USING THE RANGE: In Case of a Power Failure Surface Burners / Surface Burners










