User Manual

49-1000492 Rev. 3 11
INSTALLATION INSTRUCTIONS
WINE CENTER DIMENSIONS
Installation Instructions
REMOVE PACKAGING
NOTE: The toekick and door handle (some models)
are included in the packaging which covers the top of
the unit. A wrench for the handle installation is included
in the accessory bag located inside the wine center.
• Remove tape and glue residue from surfaces before
turning on the wine center. Rub a small amount of
liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
NOTE: Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can
damage the surface of your wine center. For more
information,see“WineCenterSafety.”
• Dispose of/recycle all packaging materials.
WARNING
Small objects are a choke hazard
for children. Remove and discard any parts not
used.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean
the inside of the wine center before using it. See the
cleaninginstructionsin“WineCenterCare.”
THE INSTALLATION SPACE
PRODUCT CLEARANCES
When installed in a corner:
•Allow4”(10cm)min.clearanceonthehingesidefor
the90°doorswingandtoallowrackstoslideout.
•Allow13”(33cm)minimumclearanceonthehinge
sideforafull115°doorswing.
Locate
Outlet in
Grey Area
34-1/2” - 35”
(87.63 - 88.9 cm)
24” (61.0 cm)
10” (25.4 cm)
Max.
24” (61.0 cm)
13" Minimum
to Wall
115°
90°DoorSwing
4" Minimum
to Wall
90°
23-3/4″
(60.3 cm)
34.1-35.1″*
(86.6-89.1 cm)
*1”ofadjustment
with leveling legs
23.40″
(59.5 cm)
47″
(119.4 cm)