Quick Guide

Café™ 30" Five in One Oven
with 240V Advantium® Technology
CSB923P4NW2 / CSB923P2NS1 / CSB923P3ND1
For answers to your Café™ product questions, visit our website at cafeappliances.ca.
C
L
21-5/8"
over centerline
WARRANTY
Parts warranty
Limited 1-year entire appliance
Limited 5-year magnetron tube
Labor warranty
Limited 1-year entire appliance
Warranty notes
See written warranty for full details
DIMENSIONS AND INSTALLATION INFORMATION
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating.
Note: 2" minimum between cutouts when installed
above warming drawer or single wall oven.
Installation information: Before installing, consult
Cabinet width
A
B
4-3/16"
Junction box location (240-volt models only)
installation instructions packed with product for
current dimensional data.
Note: Advantium 240 volt models cannot be
installed under 36 inches height.
Note: Use of the accessory drawer will replace
the bottom trim piece for applicable installations.
Please see installation instructions for full details.
20-1/8"
29-3/4"
21-1/2"
To back
of Control
Conduit
(46" long)
2-1/2" MIN. between cutouts
recommended—2" MIN. required
A
B
Construct Solid Bottom
MIN. 3/8" Plywood Supported by
2 x 4 or 1 x 2 Runners, all Four Sides.
(Must Support 150 lbs. for Advantium)
(Must Support 200 lbs. for Wall Oven)
9-1/4" cutout height
28-1/2" cutout width
2" MIN. between cutouts
2x4’s or
equivalent
solid floor
1" MIN. above toekick or adjust
to oven installation height
Suitable
bracing
to support
runners
of cabinet
(Must support 130 lbs.)
Note: Cabinets installed adjacent
to wall ovens must have an adhesion
spec of at least 194° F temperature rating.
21-1/2"
To Back of Control
20-1/8"
25-1/4"
Cutout width
A
Conduit
(48-1/2"
long)
4-3/16"
23-1/2"
Cutout depth
B
17-1/2"
Cutout height
Junction box
location
(240-volt
models only)
A= Allow 1" overlap of oven over bottom edge of cutout, and allow
2-3/4" overlap at top edge of cutout.
B= Allow 3/4" - 2-1/8" for overlap of oven over side edges of cutout.
29-3/4"
cabinet
width
Required
cutout location
36-3/4"
minimum
from floor
Construct Solid
Bottom MIN.
3/8" Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides.
(Must Support
150 lbs.)