User Guide

-p PenDiameter[mm]:
EAGLEusesthePen-diametermeasurementto
calculatethenumberoflinesrequiredwhenareas
aretobefilled.
Default:0
-q QuickPlot:
Generatesadraftorfastoutput,whichonlyprints
theframesoftheobjects.
Default:off
-r RotateOutput:
Rotatestheoutputby90degrees.
Default:off
-s ScaleFactor:
Thosedeviceswhichcannotchangetheir
scale-factor(inthemenuoftheCAMProcessor),
haveascalefactorof1.
Default:1
-t EmulateThermals:
Worksonlyincombinationwith-e+.
Default:off
-u RotateOutputby180degrees:
Incombinationwith-r+onecanrotateby270degrees.
Default:off
-v PenVelocityincm/s:
Thisoptionisforpenplotterssupportingdifferent
speeds.Toselectaplotter’sdefaultspeed,usea
valueof0.
Default:0
-w PageWidth(inch):
Printableareainxdirection.Seealso-h.
-x OffsetX(Inch):
Thisoptioncanbeusedtomovetheoriginofthedrawing.
Default:0
-y OffsetY(Inch):
Default:0
Exampleforstartingeaglecon.exe:
eaglecon -X -dgerber -Waperture.whl -oboard.sol
-D-0.1 name.brd pad via bottom
This generates a Gerber file board.sol which contains data of the layers
Pads, Vias, and Bottom. Draw apertures may have a negative tolerance
upto10%.
Allparametershavetobewritteninacommonline!
239
Appendix