User Guide

Busmenu
Clicking on the bus line while the NET command is active, opens the
menu as illustrated above. The name of the net that is to be placed is se
-
lectedfromhere.
Theindexofapartialbusnamemayrunfrom0to511.
The help system provides you with more information about the BUS
command.
SpecifyingNetClasses
The CLASS command specifies a net class. The net class specifies the
minimum track width, the minimum clearance from other signals and
the hole diameter for vias in the layout for a specific class of signals. The
default setting is net class 0, which means that none of these things are
specified.Amaximumof8netclassesispossible.
Net classes can be changed at a later date by means of the CHANGE
command(the Class option).
Thesesettingscanalsobeleftuntilyoureachthelayoutstage.
93
FromSchematictoFinishedBoard