User Guide

The gates are called A, B, C and D, and the name of the component in
the schematic is IC1, so the names which appear are IC1A, IC1B, IC1C
andIC1D.
SelectingthePackage
Now click on the New button at the lower right of the Device Editor
window. Choose the R-10 package from the selection window, and enter
a name for the version. If only one package version is used, it is usual to
use two single quote marks ('') for the name of the package version. It is,
however,quitepossibletoassignaparticularname.
Thepackageselection
Connect - ConnectionsBetweenPinsandPads
With the CONNECT command you specify which pins are taken to
whichpackagepads.
TheCONNECTwindow
The resistor gate in this example is automatically identified as G$1, for
which reason the pins G$1.1 and G$1.2 of this gate appear in the Pin
column.
The two connections of the housing are listed in the Pad column. Mark
apinandtheassociatedpad,andclickon Connect.
164
EAGLEManual