User Guide

-W ApertureWheelFile:
Thisoptiondefinesthepathtothewheelfilewhichshould
beused
-X CallscommandlineversionoftheCAMProcessor
-a AnnulusSymbolEmulation:
Default:off
-c PositiveCoordinates:
IfthisoptionissettheCAMProcessorcreatesdata
withoutnegativecoordinates.Thedrawingismoved
tothezero-coordinates.Thisoptioncanbeturned
offwiththeoption-c-.Pleasebecarefulwiththis
option,especiallyifyouusemirroredandrotated
drawings,becausenegativecoordinatesnormally
causeproblems.
Default:on
-d Device:
Thisoptiondeterminestheoutputdriver.Thefollowing
commanddisplaysalistoftheavailabledrivers:
eagle -d?
-e EmulateApertures:
Ifthisoptionisselected,aperturesthatdonotexistare
emulatedwithsmallerapertures.Ifthisoptionisturnedoff,
noaperturesareemulated.Thermalorannulusaperturesare
notemulatedeither
Default:off
-f FillPads:
Thisoptioncanonlyworkwithgenericdeviceslike
Postscript.
Default:onforalldevices
-h PageHeight(inch):
Printableregioninthey-direction(ininches).TheY
directionisthedirectioninwhichthepaperistransported.
Seealsothe-wparameter.
-m MirrorOutput:
Default:off.
-o OutputFileName
-p PenDiameter[mm]:
EAGLEusesthePen-diametermeasurementto
calculatethenumberoflinesrequiredwhenareas
aretobefilled.
Default:0
204
EAGLEManual