User Guide

CAMProcessor: Solderside sectionofthe gerber.cam job.
The diagram shows the ending .whl in the Wheel line for the aperture ta
-
ble. This means that the file democmp.whl is looked for. The output
(File) receives the name democmp.sol. The flag options Optimize and
Pos.coords. areactive.
A tolerance of 6 1% is permitted for the aperture selection. This is nec
-
essary in order to compensate for small rounding errors (of around
0.00005 inch) that can arise during the conversion from mm to inch val
-
uesastheaperturetableisgenerated.
Thestatuslinebelowshowswhichlayoutisloaded.
188
EAGLEManual