User Guide

PinName
You assign pin names with the NAME command. In our symbol the two
inputpinsarenamed A and B,andtheoutputpinisnamed Y.
DrawtheSymbol
Use the WIRE and ARC commands to draw the symbol in layer 94,
Symbols. The standard line thickness for the symbol editor is 10 mil. You
mayalsochooseanyotherlinethickness.
PlaceholdersforNAMEandVALUE
For the component labeling, use the TEXT command in the schematic
diagramtowrite
>NAME
inlayer95, Names and
>VALUE
in layer 96, Values. Place the two texts at a suitable location. It is possi
-
ble to move the texts again in the schematic diagram after using SMASH
to separate it. The symbol should now have the appearance shown in the
followingdiagram.
Save
Thisisagoodmomenttosavetheworkthatyouhavedonesofar.
TheSymbolEditor:Logicsymbol(Americanrepresentation)
161
ComponentDesignExplainedthroughExamples