User Manual
1.9.Continuous dehumidifying Mode
The default mode is continuous dehumidifying Mode
“On”.
Press the Set button to toggle the continuous
dehumidifying Mode On/Off.
If the continuous mode “off”, the humidistat mode is
automatically turned on, and then the humidistat set
point is entered for operation.
The display will communicate to the user that the
machine is continuously dehumidifyingon the last line
of the dashboard.
The set value shows “CO”.
1.10.Humidity control mode
Users can choose between two modes for controlling
humidity.
• Relative humidity=%RH
• GPP = Grains per pound (gr/lb)
1.11.Humidistat Set Point
Press the Set button to adjust the set point RH% in 5%
increments ranging from 25% RH to 80% RH and then
loop back to 25% RH. Press the Next button to confirm
selection and advance to the next screen.
Press the Set button to adjust the set point (gr/lb) in
2(gr/lb)increments ranging from 20(gr/lb) to 200(gr/lb)
and then loop back to 20(gr/lb) . Please select a
humidity setting point for adjustment.
1.12. Diagnostic Codes
If the machine has an error and needs service, the
onboard control system will display a diagnostic code. If
E1, E4, HI or LO is displayed on the vehicle control
screen, please refer to the following:
E1: Humidity Sensor or Communication Error
Solution: Check to ensure that the sensor wire is
connected at both ends, if no issues are visible, the
sensor may be faulty.
E4: Problem with Pump
5