Owner`s manual
If
an
error occurs while trying to play a cassette tape, it
could
be
that:
The cassette tape
is
tight and the cassette player
cannot turn the
hubs
of the tape. (Hold the cassette
tape with the open end down and
try
turning the right
hub counterclockwise with a pencil. Flip the tape
over and repeat. If the hubs do not turn easily, your
cassette tape may
be
damaged and should not be
used in the player.
Try
a new tape to be sure your
player is working properly.
The cassette tape is broken. (Check to see
if
your
tape is broken.
Try
a new tape.)
Note
that cassette tape adapter kits
for
portable compact
disc players will not work in your cassette player. These
adapters
will
cause
an
error message to show on the
display, and the adapter cassette will be ejected.
TAPE:
Press
this
button
to
switch from radio or
CD
to
cassette tape play. Press
AM
or
FM
1-2
to switch to the
radio.
SEEK:
Press the forward
arrow
to search for the next
selection on the tape. Press the backward arrow to
search for the previous selection on the tape
(REP
will
appear on the display). Your tape must have
at
least
three seconds
of
silence between each selection
for
SEEK
to work. The sound will be muted while seeking.
REV:
Press this left mow button to reverse the
tape
rapidly. Press it again to return to playing
speed.
The radio
will
play while the tape reverses and
REV
will
appear
on
the display. You may use your station pushbuttons to tune
to another radio station while
in
REV
mode.
FF:
Press this right arrow button to advance quickly
to
another part
of
the tape. Press the button again to return
to playing speed. The radio will play while the tape
advances
and
FWD
will appear on the display. You may
use your station pushbuttons to
tune
to another radio
station while in
FWD
mode.
SIDE:
Press this button
to
change the side
of
the tape
that
is
playing.
SCAN:
Press
this button.
SCAN
will appear
on
the
display until the next selection is found and then
PLAY
will appear on the display. Use
SCAN
to
listen to
selections for a few seconds. The tape will
go
to a
selection, stop for a few seconds, then go
on
to the next
station. Press this button again to stop scanning:
3-24