Service manual
Once the tape is playing, use the upper and lower knobs for volume,
balance, and fade just as
you
did for radio. The arrow in the graphic
display above the word
TAPE
indicates which side
of
the
tape is being
played.
PROG
To
go
from one side
of
the tape to the other, press the
PROG
button.
CrOt
This button sets the tape bias. When playing high bias chrome or metal
tapes, press the button to turn the Cr02 on in the graphic display. When
playing standard bias tapes, press again to turn the CrO2
off.
REV
To rapidly reverse the tape, press
REV
and the tape will rapidly reverse
to the beginning
of
the tape or until you press the
REV
button lightly.
To
rapidly advance the tape, press
FWD
and the tape
will
rapidly go
forward to the end
of
the tape or until you press the
FWD
button lightly.
PREV
To
hear a passage
on
the tape that has just played, press
PREV
and the
tape will back up and stop at either the first 4-second quiet spot in the
tape
or
when you press
PREV
again.
NEXT
To
go
immediately to the next selection on the tape, press
NEXT
A
4-second quiet interval must be present
for
the tape to stop.
EJECT
To
remove or stop the tape and switch to radio, press the EJECT button.