Service manual

Push-Freq (Program)
Push the upper knob when playing a tape to switch from one side of the
tape to the other.
Search
When you’re playing a tape, Search lets you jump ahead quickly to the
start
of the next selection. It makes the tape stop when it gets to the next
place with
4 seconds or more of silence. To use Search:
Slide Search to the right, then
0 Push Fwd.
If you want to go back and hear a selection you’ve just heard, Search will
do that too. Just slide Search to the right and then push REV. The tape
will
go back to the last silent place and start again from there.
Choose the right bias (or “equalization ”) for your tape.
On your radio, you’ll find a CrOiM
button:
Now look at your tape, or
on its label or box. It should say whether its
bias (“equalization”) is
70 microseconds (70 u) or 120 microseconds (120
u). If it doesn’t say, chrome and metal tapes are 70 ,u sec and standard
iron tapes are 120
u sec.
For
70, push the Cr02 button in. For 120, it should be out.
If you don’t do this, the tape will still play, but the sound will not be as
good as your system can provide.
-.
Cr
r