User's Manual

CONFIDENTIAL

CADI SmartSense – SmartNode SMN-822W User Manual

T-SMN-822-I02-A01

Regulatory Information

For customers in U.S.A and Canada

The SMN-822W (FCC ID: VPE-SMN-822W) has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that may cause undesired

operation of the device.

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

2. For body worn operation, this device has been tested and meets FCC RF exposure guidelines.

When used with an accessory that contains metal may not ensure compliance with FCC RF

exposure guidelines.

You are cautioned that changes or modifications not expressly approved by the part responsible for

compliance could void the user’s authority to operate the equipment.

For customers in Europe

This equipment has been tested and found to comply with the limits set out in the R&TTE Directive.

Where you see this symbol on any of our electrical products or packaging in Europe, it means that at end

of life the product or battery must be disposed of in accordance with any applicable laws or requirements

for the separate disposal of electrical equipment or batteries.