Installation Manual

ManualsBrandsCadet ManualsKitchenF Series Almond Baseboard Load-Transfer 240 Volt Heater to Outlet Switch Kit

1. Verify that the LTF-240 receptacle conguration (See Figure 1)

matches the appliance plug.

2. LTF must be installed at end of baseboard that carries the

incoming power supply.

3. Detach the baseboard junction box cover by removing the

retaining screw at the end where the load transfer switch will

be installed. Save the retaining screw for use in step 8.

4. Connect the 240 VAC incoming power supply wires to the

leads marked “line” on the switch (See Figure 2).

5. Connect the heater element leads to the LTF leads marked

“heater” (See Figure 2).

6. Connect the three ground wires together.

7. Check that no bare wire is exposed and that all wire

connections are tight.

8. CAUTION: Be certain the ground wires do not come in contact

with the terminal connections of the switch or outlet. Attach the

LTF plate to the heater using the screw that was set aside.

9. Turn on the power to the heater.

INSTALLATION INSTRUCTIONS

Figure 1

HEATER OUTLET

NOTES

• A single pole Cadet brand BTF1 thermostat must be

installed at the other end of the baseboard.

• NOT intended for use with wall thermostat

• Will not support double pole thermostat

ROCKER

SWITCH

LINE

HEATER

SWITCH

RECEPTACLE

OUTLET

NEMA

620R

GROUND

LTF-240

20 AMP, 240V, 60 HZ

USE ONLY ON 20 AMP, BRANCH CIRCUIT

FOR USE WITH MODELS F, M, R

UL LISTED BASEBOARD ACCESSORY 631J

LINE

GROUND

HEATER

SWITCH

LTF-240

20 AMP, 240V, 60 HZ

USE ONLY ON 20 AMP, BRANCH CIRCUIT

FOR USE WITH MODEL F

UL LISTED BASEBOARD ACCESSORY 631J

RECEPTACLE

Figure 2

WARRANTY

LIMITED ONE-YEAR WARRANTY: Cadet will repair or replace any Cadet

product, including thermostats, found to be defective within one year after the

date of purchase.

These warranties do not apply:

1. Damage occurs to the product through improper installation or incorrect

supply voltage;

2. Damage occurs to the product through improper maintenance, misuse,

abuse, accident, or alteration;

3. The use of unauthorized accessories or unauthorized components constitutes

an alteration and voids all warranties. Refer to Cadet website or call customer

service at 855.CADET.US for list of authorized accessories and components.

4. CADET’S WARRANTY IS LIMITED TO REPAIR OR REPLACEMENT.

5. IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR CA-

DET PRODUCT, THE REPLACEMENT PARTS ARE SUBJECT TO THE

SAME WARRANTIES AS THE PRODUCT. THE INSTALLATION OF RE-

PLACEMENT PARTS DOES NOT MODIFY OR EXTEND THE UNDERLYING

WARRANTIES. REPLACEMENT OR REPAIR OF ANY CADET PRODUCT

OR PART DOES NOT CREATE ANY NEW WARRANTIES.

If you believe your Cadet product is defective, please contact Cadet

during the warranty period, for instructions on how to have the repair or

replacement processed.

Parts and Service

Visit cadetheat.com/parts-service for information on where to obtain parts

and service.

Reduce-Reuse-Recycle

This product is made primarily of recyclable materials. You can

reduce your carbon footprint by recycling this product at the end

of its useful life. Contact your local recycling support center for

further recycling instructions.

For more effective and safer operation and to prolong the life of the heater, read the Owner’s Guide and follow the instructions. Failure to

properly maintain the heater will void any warranty and may cause the heater to function improperly.

OPERATING INSTRUCTIONS

Use the rocker switch to direct power to the baseboard heater OR the 240 volt outlet (See Figure 1).