Use and Care Manual

2
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
1. Read all instructions before
installing or using this heater.
2. This heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. Keep
combustible materials, such
as furniture, pillows, bedding,
papers, clothes, etc. and curtains
at least 3 feet (0.9 meters) from
the front of the heater and keep
them away from the sides.
3. Extreme caution is necessary
when any heater is used by or
near children or invalids and
whenever the heater is left
operating and unattended.
4. Do not operate any heater after
it malfunctions. Disconnect
power at service panel and have
heater inspected by a licensed
electrician before reusing.
5. Do not use outdoors.
6. To disconnect heater, turn
control(s) to o󰀨, and turn o󰀨
power to heater circuit at main
disconnect panel.
7. Do not insert or allow foreign
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or fire, or
damage the heater.
8. To prevent a possible fire, do not
block air intakes or exhaust in
any manner.
9. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable vapors or liquids
are used or stored.
10. Use this heater only as
described in this manual. Any
other use not recommended by
the manufacturer may cause
fire, electric shock, or injury to
persons.
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
KNOW YOUR VOLTAGE!
120 volt
single-pole breaker
240 volt
double-pole breaker
If you are uncomfortable working with electricity, running electrical supply wire or
installing a circuit breaker, please consult a licensed electrician. Make sure power
to the heater is turned o󰀨 at the main disconnect panel whenever doing any work
on a heater. Serious injury or electrocution can result from electric shock.
• CHECK YOUR BREAKER! If you’re replacing an existing heater, check the
labels of the old heater and use the same voltage.
Unanswered questions? Call our technical support team in Vancouver,
Washington toll free at 855.223.3887 or outside the USA 360.693.2505
WARNING: Connecting a heater to a voltage higher than what’s listed on its
rating label will destroy the heater and could start a fire.
A heater will not heat properly when connected to a voltage lower than what’s
listed on its rating label.