Use and Care Manual

ManualsBrandsCadet ManualsElectric Wall Heaters500-Watt 120-Volt Pumphouse Frost Protection Heater

WARRANTY

For more e󰀨ective and safer operation and to

prolong the life of the heater, read the Owner’s

Guide and follow the instructions. Failure to

properly maintain the heater will void any warranty

and may cause the heater to function improperly.

LIMITED TWO-YEAR WARRANTY: Cadet will

repair or replace any Frost Protection (FP) heater

found to be defective within two years after the

date of purchase.

These warranties do not apply:

1. Damage occurs to the product through improper

installation or incorrect supply voltage;

2. Damage occurs to the product through improper

maintenance, misuse, abuse, accident, or

alteration;

3. The use of unauthorized accessories or

unauthorized components constitutes an

alteration and voids all warranties. Refer

to Cadet website or call customer service

at 855.223.3887 or 360.693.2505 for list of

authorized accessories and components.

4. Cadet’s warranty is limited to repair or

replacement.

5. In the event Cadet elects to replace any part

of your Cadet product, the replacement parts

are subject to the same warranties as the prod-

uct. The installation of replacement parts does

not modify or extend the underlying warranties.

Replacement or repair of any Cadet product or

part does not create any new warranties.

If you believe your Cadet product is defective,

please contact Cadet during the warranty period,

for instructions on how to have the repair or

replacement processed.

Parts and Service

Visit cadetheat.com/parts-service for information

on where to obtain parts and service.

To register your product, visit cadetheat.com/product-registration

INTERNAL HEATER WIRING DIAGRAMS

L2/N

HIGH

TEMPERATURE

SAFETY SWITCH

ADJUSTABLE

THERMOSTAT

40°F - 85°F

(4°C - 30°C)

HIGH

TEMPERATURE

SAFETY SWITCH

ADJUSTABLE

THERMOSTAT

40°F - 85°F

(4°C - 30°C)

L2/N

HIGH

TEMPERATURE

SAFETY SWITCH

ADJUSTABLE

THERMOSTAT

40°F - 85°F

(4°C - 30°C)

HIGH

TEMPERATURE

SAFETY SWITCH

ADJUSTABLE

THERMOSTAT

40°F - 85°F

(4°C - 30°C)

FP102T (dual element)FP051T FP052T (single element)

MAINTAINING YOUR HEATER

Clean heater at least every 6 months or as required. The heater must be

inspected every 6 month or more if conditions warrant it. It is essential that

the heater is not operated with an accumulation of dust, dirt or debris on the

heater or inside the heating chamber.

1. Turn o󰀨 power at the main disconnect panel.

2. Wait for the heater to cool.

3. Remove the cover and clean with a damp

cloth.

4. Carefully clean the heating chamber with a

vacuum. Do not touch the heating element

ﬁns.

5. Replace and secure the cover.

6. Turn power back on at the main disconnect

panel.

Any service other than cleaning should be performed by an authorized

service representative.

High-temperature safety shuto󰀨

All Frost Protection heaters come with a built-in high-temperature safety shuto󰀨 that stops electricity

ﬂowing to the heater if it gets too hot inside. This automatically resets after cooling.

Reduce-Reuse-Recycle

This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling

this product at the end of its useful life. Contact your local recycling support center for further recycling

instructions.

Rev 06/20/19 #720136

If you are uncomfortable working with electricity, running electrical supply

wire or installing a circuit breaker, please consult a licensed electrician.

CLEANING INSTRUCTIONS