Use and Care Manual

3
TOOLS REQUIRED
Tape Measure
Straight and Phillips
ScrewdriversAppropriate ScrewsWire Strippers Wire Connectors
½" Conduit
Connector
Volt Meter
Drill and Drill Bits
Stud Finder
®
®
®
®
®
Hammer
®
®
®
®
INSTALLATION INSTRUCTIONS
1. All electrical work and materials
must comply with the National
Electric Code (NEC), the
Occupational Safety and Health
Act (OSHA), and all state and
local codes.
2. Use copper conductors only.
3. DO NOT install the heater directly
above bathtub or sink. DO NOT
install in shower stall area.
(Manufacturer recommends a
minimum 2 foot (61 cm) clearance
to prevent contact with water).
4. A GFCI protected branch circuit is
recommended when installed in a
wet or damp area.
5. Heater must be installed against a
rigid surface.
6. DO NOT install the heater
anywhere the air discharge may
be blocked in any manner.
7. To reduce the risk of fire, do not
store or use gasoline or other
flammable vapors and liquids in
the vicinity of the heater.
8. Connect grounding lead to
grounding screw provided. Keep
all foreign objects out of heater.
PARTS OF YOUR HEATER
high-temperature
safety shuto󰀨
TOP VIEW (FP102 PICTURED)
heater
element(s)
built-in
thermostat