Full Product Manual

ManualsBrandsCadet ManualsHeating, Ventilation, and Air ConditioningSoftHeat EBKN Series Double-Pole Integral 22 Amp End Cap Thermostat Kit in White

Make sure all wires are properly connected and installation is complete

before you turn on the heater.

How to operate your heater

The room temperature is controlled by the thermostat on the heater. Once installation is complete

and power has been restored, follow the steps below for your thermostat:

1. Turn the thermostat knob all the way to the right.

2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the

heater turns o󰀨. The heater will automatically keep the room temperature around this setting.

3. To reduce the room temperature, turn the knob to the left. To increase the room temperature, turn

the knob to the right.

INTERNAL HEATER WIRING DIAGRAMS

Rev 08/20/20 #706982

Reduce-Reuse-Recycle

This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling

this product at the end of its useful life. Contact your local recycling support center for further recycling

instructions.

WARRANTY

For more e󰀨ective and safer operation and to prolong the

life of the heater, read the Owner’s Guide and follow the

instructions. Failure to properly maintain the heater will

void any warranty and may cause the heater to function

improperly.

LIMITED ONE YEAR WARRANTY: Manufacturer

will repair or replace any hydronic baseboard EBKN

thermostat found to be defective within one year after the

date of purchase.

These warranties do not apply:

1. Damage occurs to the product through improper

installation or incorrect supply voltage;

2. Damage occurs to the product through improper

maintenance, misuse, abuse, accident, or alteration;

3. The use of unauthorized accessories or unauthorized

components constitutes an alteration and voids all

warranties. Refer to Manufacturer website or call

customer service at 888.346.7539 for list of authorized

accessories and components.

4. Manufacturer’s warranty is limited to repair or

replacement.

5. In the event Manufacturer elects to replace any part

of your product, the replacement parts are subject to

the same warranties as the product. The installation of

replacement parts does not modify or extend the under-

lying warranties. Replacement or repair of any product or

part does not create any new warranties.

If you believe your product is defective, please contact

Manufacturer during the warranty period, for instructions

on how to have the repair or replacement processed.

Parts and Service

Visit gdaheat.com/parts for information on where to

obtain parts and service.

More frequently asked questions on our website here: gdaheat.com/FAQ

To register your product, visit gdaheat.com/register

Black

Ground

All wiring connections inside wiring compartment

Black

Red

Black

White (120V) or Orange (208V)

Neutral

Ground

All wiring connections inside wiring compartment

Black

Red

120 volt only

Figure 4

Wiring Diagram for use with

240 and 208 volt heater

Two hot supply wires

Figure 2

Wiring Diagram for use with

120 and 208 volt heater

One hot, one neutral supply wire

All wiring connections inside wiring compartment

Black

Ground

Black

BlackBlack Red

Red

All wiring connections inside wiring compartment

Black

with

label

Neutral

Ground

Black

Red

120 volt only

Wiring Diagram for use with

240 and 208 volt heater

Two hot supply wires

Figure 3

Wiring Diagram for use with

120 and 208 volt heater

One hot, one neutral supply wire

Figure 5

All wiring connections inside wiring compartment

OPERATING INSTRUCTIONS