Owners Manual

1. If heater is installed, remove grill and heatbox.
2. Fasten thermostat to lower left corner of heat box cover
behind bottom flange. Use two no. 6 - 32 x 1/4 inch
screws. Exact location will have to be determined when
the grill is installed. The longer part of the thermostat body
must point to the right. Shaft should come through the
large center hole. This is required to fit the heater into the
wall can.
Thermostat Installation Instructions
General Safety Information
Keep for future reference
If you are uncomfortable working with electrical appliances, unable to follow these guidelines, or do not have the necessary
equipment, consult a licensed electrician.
Installation Instructions
WARNING
Turn the electrical power off at the electrical panel
board (circuit breaker or fuse box) and lock or tag
the panel board door to prevent someone from turn-
ing on power while you are working on the heater.
Failure to do so could result in serious electrical
shock, burns, or possible death.
For Cadet C & CT Series Heaters
3. (A) For double pole thermostats*
Connect one black lead of the thermostat to one lead from the
heater. Connect the other black lead to the other lead from the
heater. Connect one red lead from the thermostat to one of the
supply lines. Connect the other red lead to the other supply
line. Use approved insulated wire connectors.
(B) For single pole thermostats**
Connect black lead from the thermostat to one lead from the
heater. Connect the red thermostat lead to one supply line.
Connect the other lead from the heater to the other supply
line. Use approved insulated wire connectors.
4. After installation (or reinstallation) of the heater and the grill,
check thermostat shaft alignment with the center of the grill
hole. Adjust position of the thermostat on the heat box cover if
necessary. Push knob on shaft securely - check alignment.
Tools Required: Phillips Screwdriver, Insulated Wire Connectors (Wire Nuts®)
P/N 720010 09/03
TEL: [phone] Fax: [phone] P.O. Box 1675 Vancouver, WA 98668-1675
* Double pole thermostat is not necessary on 120 volt service.
** Single pole thermostats may be used with 120 volts or 240 volts.
Double Pole Thermostat
Single Pole Thermostat