Instructions / Assembly
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling
this product at the end of its useful life. Contact your local recycling support center for further recycling
instructions.
7
More frequently asked questions on our website here: cadetheat.com/support/FAQ
1. Make sure all wires are properly
connected and installation is com-
plete before you turn on the heater.
2. Do not operate without grill.
3. Do not tamper with the high-
temperature safety shuto.
How to operate your heater
The room temperature is controlled by a thermostat located either on the wall, or on the heater. Once
installation is complete and power is on, follow the steps below for your thermostat.
If you have a wall or built-in thermostat with a knob:
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
heater turns o. The heater will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature, turn
the knob to the right.
If you have an electronic wall thermostat, follow the instructions in the programming and operating
guide included with your thermostat.
OPERATING INSTRUCTIONS
Complete installation
After installation, turn your heater to the highest setting and let it run for 30 minutes. Some smoking may
occur as the element initially burns o residue from manufacturing.
If your heater shows signs of overheating, such as glowing red or repeatedly getting unusually hot and
shutting o, immediately turn o the circuit breaker and review the “KNOW YOUR VOLTAGE” section
or call us.
If the high-temperature safety shuto trips more than once a day, replace the heater.
High-temperature safety shuto
All Com-Pak heaters come with built-in high-temperature safety shutos that stop electricity flowing to
the heater if it gets too hot inside. See TROUBLESHOOTING below if you’re experiencing problems
with your heater.
MAINTAINING YOUR HEATER
Clean heater at least every 6 months or as required. Do not lubricate motor.
WARNING: Risk of electrical shock, turn o power before removing grill.
1. Turn o power at the main disconnect panel.
2. Wait for the heater to cool.
3. Remove thermostat knob (if any) and grill.
4. Wash grill with hot soapy water and dry.
5. Blow air through the heating element with a
hair dryer or shop vacuum on blow cycle.
6. Clean the fan with a vacuum cleaner.
7. Replace grill and thermostat knob (if any).
8. Turn power back on at the main disconnect
panel.
Any service other than cleaning should be performed by an authorized service
representative.