Warranty
INSTALLATION INSTRUCTIONS
3
TOOLS REQUIRED
1. All electrical work and materials
must comply with the National
Electric Code (NEC), the Occu-
pational Safety and Health Act
(OSHA), and all state and local
codes.
2. Use copper conductors only.
3. DO NOT install the heater directly
above bathtub or sink. DO NOT
install in shower stall area. Cadet
recommends installing your heater
at least 2 feet (61 cm) away to
prevent contact with water.
4. Heater must be connected to a
GFCI protected branch circuit when
installed in a bathroom.
5. Heater must be installed in a wall
can:
Model CS - wall can models CC
or CCSM
Model CST - wall can model
CTC (WC1)
6. DO NOT install the heater in a floor,
below a towel bar, behind a door,
or anywhere the air discharge may
be blocked in any manner.
7. To reduce the risk of fire, do not
store or use gasoline or other
flammable vapors and liquids in
the vicinity of the heater.
8. Connect grounding lead to ground-
ing screw provided. Keep all for-
eign objects out of heater.
9. Electric heaters must be installed
on a circuit dedicated to electric
heaters, they cannot share a cir-
cuit with outlets, lights, or other
appliances.
Tape Measure
Straight and Phillips
Screwdrivers1½" Wood ScrewsWire Strippers Wire Connectors
½" Cable Clamp
Connector
Volt Meter
Drill and Drill Bits
Stud Finder
A multi-purpose tool or something to cut your existing drywall or gypsum board.
®
®
®
®
®
®
Hammer
®
®
®
®
PARTS OF YOUR HEATER
built-in thermostat
(optional)
rating label
heater element
fan and
motor
high-temperature
safety shutos