Installation Guide

ManualsBrandsCadet ManualsKitchen14 in. x 16 in. 5,000-Watt Industrial Unit Heater

www.cadetheat.com Tel: 360-693-2505 PO Box 1675 Vancouver, WA 98668-1675

Benets You Can Depend On

SAVE THESE INSTRUCTIONS

CEH Industrial Unit Heater

Owner’s Guide

TOOLS REQUIRED:

• Phillips Screwdriver

• Straight Screwdriver

• Wire Strippers

• Crescent Wrench

• Appropriate Fasteners

• Insulated Wire Connectors

• (1) Strain Relief Connector

• Commercial grade high temperature manual reset

for safety

• High mass, tubular element for longer life

• Fan delay eliminates cold draft on startup and

disperses residual heat on shutdown

• Rugged die formed construction for durability

• Wire single or three phase to suit the application

• Vertical or horizontal delivery

• Your Cadet heater has been thoroughly tested and

is guaranteed with a 5 year extended warranty

CEH Models

Line

Voltage

Model without

thermostat

Watts Amps

240

(1)

CEH005P 5000 20.83

(1)

240 volt models can be used at 208 volts. Wattage equals 75% of 240v rated

wattage.

Recommended for elevations under 7500 feet.

http://www.cadetheat.com/products/garage-heaters/CEH

Page 1

New installation requires a thermostat (sold separately): Model Numbers

CEKTB1 and CEKTB2 are optional built-in thermostat kits.

New installation requires mounting hardware (sold separately): Model

Numbers CEKM1 and CEKWM are optional brackets.

Summary of content (8 pages)

PAGE 1
CEH Industrial Unit Heater Benefits You Can Depend On Owner’s Guide http://www.cadetheat.com/products/garage-heaters/CEH • Commercial grade high temperature manual reset for safety • High mass, tubular element for longer life • Fan delay eliminates cold draft on startup and disperses residual heat on shutdown • Rugged die formed construction for durability CEH Models Line Voltage Model without thermostat Watts Amps 240 (1) CEH005P 5000 20.83 (1) 240 volt models can be used at 208 volts.
PAGE 2
IMPORTANT INSTRUCTIONS WARNING When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before installing or using 7. WARNING this heater. Risk of Electrical Shock. Do not insert or allow foreign objects to enter any ventilation or exhaust 2. WARNING opening as this may cause an electric shock or Risk of Fire. This heater is hot when in use. fire, or damage the heater.
PAGE 3
Before you begin, you should know... ...where to place your CEH heater Install the CEH unit heater vertically or horizontally. Brackets are also available for ceiling mount or wall mount applications. ...the thermostat requirements For single-phase only, a line voltage thermostat is required for operation. For three-phase, a two-stage or modulating thermostat is required. A Cadet wall thermostat is recommended for ultimate control and comfort. ...
PAGE 4
INSTALLATION INSTRUCTIONS 1. WARNING Verify that the electrical supply wires are the same voltage as the heater. 2. If replacing an existing heater, check the label of the old heater. 3. All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes. 4. If you need to install a new circuit or need additional wiring information, consult a qualified electrician. 5. Copper conductors are preferred.
PAGE 5
WIRING INSTRUCTIONS CAUTION: TO AVOID ELECTRICAL SHOCK, BE SURE ELECTRICITY IS TURNED OFF AT ELECTRICAL PANEL BOARD BEFORE WIRING. Connect grounding lead to grounding lug provided. All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes. NOTE: Connect heater only to a branch circuit with the voltage and frequency specified on the nameplate.
PAGE 6
OPERATING INSTRUCTIONS WARNING Risk of Electrical Shock and Fire. The heater must be properly installed before it is used. 1. Do not operate without grill. 2. Keep electrical cords, drapery, furnishings and other combustibles at least 3 feet away from the front of the heater and 6 inches away from the sides. 3. Do not tamper with the over temperature limit control. 4. If the heater over temperature limits trip more than once per day, the heater must be replaced.
PAGE 7
MAINTAINING YOUR HEATER Maintenance As Needed, or every six months minimum. WARNING! Before removing grill, turn the electrical power off at the electrical panel board (circuit breaker or fuse box). Lock or tag the panel board door to prevent someone from accidentally turning the power on while you are working on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
PAGE 8
MAINTAINING YOUR HEATER (continued) Parts List IMPORTANT: When ordering replacement parts, specify the heater “Model Number” and “Product Date Code” shown on unit rating plate or label found inside access door. Select appropriate “Part No.” from this sheet for each part requested. Specifications or designs are subject to change or discontinuance without notice or without incurring obligation. Parts List 1. 402028 2. 001601 3. 051408 4. 050326 5. 052403 6. 052402 7. 052401 8. 09670 9. 09660 10. 410102 11.